Plunger Pumps
The PNEUMATIC RELAY is a pilot operated valve designed to provide the higher air or gas flow rates necessary for PNEUMATIC DRIVE CYLINDER diameters greater than 3 inches. The PNEUMATIC RELAY is actuated by the pulses produced by the TC-XII OSCILLAMATIC® CONTROLLER. A single acting PNEUMATIC RELAY is...
Hydraulic Pump
Electrical PumpThe pump is a plunger type, it needs to be driven by a motor and recommend using electric motor. These pumps can be used on wellhead control panel systems, Power pac
Hydraulic Regulator
Turning the handle clockwise will increase the spring exerted tension to increase the regulator output pressure. Rotating the handle counter-clockwise will decrease the regulator o
Solenoid Valve
This solenoid valve is a two-position three-way valve, which is a normally closed valve controlled by an electromagnetic actuator. It can be used independently or in conjunction wi
onshore Piston-type Hydraulic Accumulator
The versatility of piston accumulators allows them to be used in 90% of applications-ranging from small-volume units to those with capacities of thousands of liters, an
offshore Stainless steel bladder-type
Designed specifically for offshore environments, this high-pressure stainless steel bladder accumulator boasts a maximum operating pressure of 6,000 PSI. It features a gas-tested r
Pressure Switch Valve
The Pressure Switch valves are operated by the pressure applied to the sense port acting on a piston opposing an adjustable spring force. 3 way valve is a block and bleed valve.It
relay valve
The MRR series relays are multi-pressure control valve for production control and safety systems. It functions as a manual reset, pilot operated, normally closed, block and bleed v
Quick Exhaust Valve
Quick Exhaust ValveThe quick exhaust Valve is designed to rapidly bleed the control pressure from an actuator or other device .It is typically used on safety valves, control valves
interface valve
Interface Valves are normally closed block and bleed Hydraulic Controllers. They allow the system to control Hydraulic pressures as high as 10,000 psi with a relatively low Pilot S